4/17/2024 0 Comments Rain spout diverter diyThis only makes sense, though, if you have a downspout diverter. Option 1: Downspout goes directly into the rain barrel. You need a hole for the rainwater to enter the barrel. I had to stick my head into the barrel to reach it! □ 6. The melted plastic formed a watertight seal around the spigot when it cooled. I also saw a video where someone installed rain barrel spigots by melting the hole and quickly screwing the spigot into place. Wrap the male part of the spigot threads with the plumber’s tape. And then, you screw the spigot into the hole. ![]() Then put some caulk on the back of the washer. Put the O-ring and a washer on the outside of the barrel.Add an O-ring over the spigot threads and put a washer over the O-ring. O-ring and washer inside the barrel: Screw the spigot into the hole you just drilled.It was fairly hilarious because I had to stick my entire head into the barrel to reach the lower spigot. I used the first method with an O-ring and washer. It doesn’t affect performance but is something to be aware of. Because the bottom of most rain barrels is convex, the bottom spigots on my blue barrels ended up sitting at a weird angle. Some barrels have an indentation on the bottom for drilling a hole.Ensure you leave enough room between the bottom hole and the barrel’s bottom, so the spigot doesn’t hit the ground once installed.You’ll need to check the size of your spigot threads to know which drill bit to use. This allows you to drain the barrel without it getting clogged too easily.Īlso read: Tips for Choosing Rain Barrels 4. The bottom spigot should be approximately 3 inches from the base of the barrel. You only use the bottom spigot when you drain the barrels for winterizing or cleaning. By contrast, the water will be cleaner if you put a spigot near the middle. The water will always be murky if you only have a spigot on the bottom. Sediment and debris will inevitably get into the barrel and settle on the bottom. You should have TWO spigots: one near the bottom and another near the middle. It drives me crazy that so many rain barrels only have a spigot on the bottom. Even if your rain barrels are new, you should rinse them to remove any plastic residue. In my case, the barrels were filled with spider webs and other debris, so they needed to be cleaned out. Likewise, the containers should be food safe if you want to drink the rainwater you collect. However, you don’t want to use containers that contained hazardous materials. For example, a lot of people use trash cans. You can also use pretty much any large plastic container for your rain barrels. They were used to make sour cabbage (the previous owner was Serbian, and they love their stuffed cabbage!), so the barrels were safe for rainwater. ![]() ![]() ![]() I was lucky that there were already three large barrels on the property. This DIY rain barrel kit is great and includes a downspout diverter that allows leaves to pass through as well as winterizing items. Invest in a good metal spigot, especially if you want to connect the rain barrel to a hose. Note: I used a PVC spigot and regretted it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |